Modern Stone Enhancer Water Base

Modern Stone Enhancer Sealer

Water Base

Available: Gallon, Quart, Pint, 5 gal

Professional Results . . . GUARANTEED!

This water-based enhancing sealer darkens and enriches the beauty of natural stone, concrete and masonry. Its formula also provides strong protection agains oil & water based stains with almost no VOC’s.

Modern Stone’s Enhancer (Reveal & Seal) is a premium water based, enhancing sealer formulated to darken, highlight and enhance the beauty and character of natural stone. Reveal & Seal’s U.V. resistant formula provides maximum stain protection from oil and water based stains. It allows for moisture vapor transmission and can be used for indoor and outdoor applications.

Uses:

Marble, Granite, Limestone, Travertine, Quartzite, Slate, Sandstone

Test in an inconspicuous area and allow 24 hours to cure to determine ease of application and desired results.

VOC: 07 g/l

A water based enhancing sealer formulated to darken, highlight and enhance the beauty and character of natural stone. with very low odor.

Use on marble, granite, limestone, travertine, concrete/masonry, saltillo tile, clay tile, stucco, terrazzo, and grout. Test in an inconspicuous area and allow 24 hours to cure to determine ease of application and desired results.

• Unsurpassed Water & Oil Resistance
• U.V. resistant formula
• No Unpleasant Odor (very low odor)
• Safe to Use
• Easy to Apply
• Long Lasting
• Resists Mildew
• VOC Compliant

Application

1. Ensure surface is clean, dry and free of waxes or coatings.

2. Agitate bottle before use.

3. Apply Reveal & Seal liberally using a paint pad, roller, brush, lambs wool applicator or low-pressure chemical sprayer. Distribute product evenly over entire surface to ensure uniform coverage and maximum penetration.
*Note: Reveal & Seal provides maximum enhancement. A lighter first application may be recommended in order to determine substrate's porosity. Over applying enhancer may cause excess product to dwell on surface and make clean up more difficult. Do not allow excess sealer to dry on surface.

4. Allow sealer to dwell for up to 20 minutes, or until it begins to dry on surface. Remove excess with cotton bonnet pad or clean towels, until surface is completely dry.

5. For more porous substrates if darker appearance is required, apply a second coat 30 minutes after initial application.

6. Ready for foot traffic in 4 hours. Fully cures in 24-48 hours.

7. Clean tools with mineral spirits

Covers Approximately 200 to 1500 sq. ft per gallon. (Will vary widely depending on porosity and absorbency rate of surface to be sealed. Temperature and application method will also affect coverage.)

Handling and Storage

Close container after each use. Store in original container only. Keep in a dry, well-ventilated area. Avoid freezing or long-term high temperature storage. Do not place near heat, sparks, fame or other sources of ignition. DO NOT THIN OR DILUTE

Caution:

Rubber gloves and eye protection should be worn during application. Avoid contact with eyes and skin. Immediately flush eyes with water. If skin contact occurs wash with soap and water. Do not take internally. Do not induce vomiting. Seek medical attention.

Modern Stone Product Coverage Chart

Modern Stone Product Specifier Chart

Clear Guard Solvent MSDS