Glaze N Seal Stain Defense Sealer Quart

Glaze N Seal Stain Defense Sealer Quart

Unmatched Protection on all Natural Stone, Tile, Grout, Granite Marble, Brick, Masonry and Concrete

Glaze ’N Seal Stain Defense Sealer is an exciting "State-ofthe- Art" "Natural Look" penetrating sealer for water, oil and stain resistance on all granites, marble, fine stone, tile and masonry

Indoors and Outdoor

Natural Look Sealer

Odor Free - Oil Resistant - Efflorescence Resistant - Water Resistant - Mildew Resistant - Seals Grout

Environmentally Friendly

Professional Result Guaranteed!

• NO UNPLEASANT ODOR
• RESISTS EFFLORESCENCE
• UNSURPASSED WATER & OIL RESISTANCE
• EXCELLENT AS A GROUT SEALER
• SAFE TO USE
• EASY TO APPLY
• ETCH FREE FORMULA
• ONE FORMULA FOR ALL STONE
• LONG LASTING
• RESISTS MILDEW

Uses:

Recommended for all absorbent stone and tile, even the most porous, where damage from staining is a concern:

• Marble • Granite • Adoquin • Sanded Grout • Porcelain Tile • Flagstone • Slate • Terrazzo • Cantera • Unglazed Tile • Quarry Tile • Brick • Travertine • Limestone • Saltillo Tile • Ceramic Tile • Masonry • Sandstone • Cement • Concrete Tile • Terracotta Pavers

Coverage:

Coverage rate of Stain Defense Sealer will vary widely depending on porosity and absorbency rate of surface to be sealed. Temperature and application method will also affect coverage.

One quart will seal between 50-400 square feet. In most instances, expense of labor exceeds material cost of sealing project. Do not under apply the product as the labor cost of doing the job twice exceeds the material costs.

Directions

On new installations, apply to all surfaces before grouting to assist in easy clean-up and to resist grout staining. Apply liberal amount of Stain Defense with a new clean brush, roller, or paint pad. Allow sealant to soak into surface. On very porous surfaces a second coat may be applied one hour later. Allow to dry overnight before grouting.

After grout has cured and tile has been thoroughly cleaned, apply an additional coat of Stain Defense over the entire surface including grout. Wipe excess sealant from surface after 10 minutes with a clean towel.

Cure Time: Stain Defense cures in 24 hours. Allow surface to dry for 4 hours or overnight, before allowing traffic. Keep surface free from staining materials for 72 hours. NOTE: Apply when temperature is between 50ºF – 90ºF. Avoid puddling and rundown. If sealant comes in contact with surrounding surface, wipe off. If residue appears, reapply some Stain Defense and buff surface with a clean towel. Coverage rate of Stain Defense Sealer