Alpha Tools EZ Thin Tile Cutters

Alpha Tools EZ Thin Tile Cutters

Fast & Accurate Cutting Tools

Introducing EZ Thin Tile Cutters that are designed to score and snap upcoming new thin materials, such SlimLite™ from Daltile® and Laminam® from Crossville® just name a few. The tile or panel can be scored with a ruler then snapped manually or cut with EZ T-Cutter for an accurate and fast cutting application as long as there is no texture on the surface. (See Spike Ruler for thin porcelain tiles or panels with texture on the surface).

Equipment Included: 24" T-Cutter, Slimline Cutter, Plier & Oil

Features

• Designed for Cutting By Score & Snap Method
• Great On Tile and Thin Panels Such As StonePeak, Slimlite™, Laminam®, Etc.
• Convenient and Easy To Use
• Clean Breaks Every time
• T-Cutter Designed for Fast, Precision Cutting
• Use with Spike Ruler for Textured Surfaces
• Low Maintenance and Long Service Life

How to Use

Open the self-lubricating reservoir and fill with the Alpha® EZ Cutter Oil (Part No. KOC1000)

Before making the score, test to make sure that the EZ Cutter is dispensing oil.

Align the Alpha® Spike Ruler to the line on the material that needs to be scored if you are using the Slimline or Pistol Type Oil Cutters. If you are using the T-Cutter, you do not need the Spike Ruler.

Place the EZ Cutters scoring wheel on the edge of the material, while applying consistent down pressure pull the EZ Cutter towards you in a continuous non stopping motion till you reach the end of the material. Close the self-lubricating reservoir.

Position the Alpha® Running Pliers (Part No. KOC512P) on the score mark and squeeze the handles to apply pressure on the scored material. The material will snap following the score mark across the material. TIP: Teaming up and using two Alpha® EZ Glass Running Pliers at the same time with one on each side of the long panel is optional but recommended so the snapped panel does not get damaged.

If the material has fiberglass on the back surface, you will need to use a razor blade to cut the fiber glass after the material has been snapped.

It is recommended after the material has been scored and snapped, use the Alpha® Electroplated Hand Pads (#60 or #150 grit) to remove the sharp edges. (Part No. DHP0060 or DHP0150)

Helpful Hints

Use the Alpha® Spike Ruler for precision scoring with the EZ Thin Tile Cutters.

Replacement cutting head for the EZ T-Cutter is available for purchase, Part No. KEC1902

While applying consistent down pressure, pull the EZ Cutter towards you in a continuous non stopping motion till you reach the end of the material. This will allow you to achieve a successful score mark on the surface of the material.

An automatic oil feed dispenser is included within the packaging of the EZ Thin Tile Cutter (Slimline & Pistol Type) Oil Cutters to help you fill the reservoirs chambers with the EZ Cutter Oil.

Teaming up and using two Alpha® EZ Glass Running Pliers at the same time with one individual on each side of the long panel is optional but recommended so the snapped panel does not get damaged.